ITI Straumann Tissue Level SynOcta® Implant Internal Titanium Premill Blank 14mm Engaging
NN(3.5) / RN(4.8) / WN(6.5)
Ti 6AI-4V ELI (Supply from Germany)
* Simply efficiency
* Precision machined up to ± 5µm
* Benefit from a faster and controlled turnaround time
* Different diameter available of 10mm, 14mm
Pre-milled Abutment Blanks, you can now produce titanium customised abutments with your milling equipment.
Boost your efficiency by using your milling machines and benefit from all major implant connections.
Approved by CE, ISO 9001, ISO 13485
* We also can provide another 3 type of premill as above picture shown. Welcome to further inquire. Thanks.
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 14mm are designed to be used for the production of custom titanium abutments.
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 10mm should only be used for the application described.
The following conditions would contraindicate use of Inclusive Titanium Abutment Blanks:
Wall thickness less than 0.5 mm
Gingival margin diameter less than 0.5 mm wider than the implant
Angle corrections of more than 30 degrees
Less than 0.5 mm margin height
Less than 4.0 mm post height
Hybrid abutments (zirconia abutments with titanium base) are contraindicated by the conditions listed above, and in cases with angle correction or gingival height greater than 6 mm. A patient-specific finished device will consist of both the titanium base and zirconia coping.
ITI Straumann Tissue Level SynOcta® Titanium Premill Blank 14mm are shipped NON-STERILE. Non-sterile items must be cleaned, disinfected, and sterilized prior to clinical use, according to a validated method.
Cleaning: Wash using a broad spectrum cleaning solution, followed by thorough rinsing and drying.
Disinfection: Immerse abutments in disinfectant, rinse with distilled water and dry.
Sterilization: Gravity-fed sterilizers: Autoclave in sterilization pouch for 15 minutes at 132°C (270°F). Allow sterilized components to dry for at least 30 minutes.